Farm Equipment Rentals
Harvesting Equipment Rentals

Renting a Mower-Conditioner for Hay

Rent a mower-conditioner for hay: disc or sickle cutterbars, roll or flail conditioning, cutting height, drying, tractor needs, daily service, safety and a plan to the baler.

5 min read1,014 wordsUpdated November 2026
Renting a Mower-Conditioner for Hay: illustration of a combine unloading grain into a cart

A mower-conditioner cuts hay and conditions it in a single pass, so it dries faster than hay left uncrushed. It is the first step in most hay systems, and a rental mower-conditioner lets a farm cut quality hay without owning the machine. This guide explains types, setup, service and planning around the baler.

What the machine does

The cutterbar cuts the crop, then rolls or flails crimp and crush stems so moisture escapes. The crop exits through a shield that forms a swath or windrow. Faster drying reduces weather risk and improves feed quality.

Compare with renting a swather for hay and grain and windrower rentals: hay and specialty crops, which are self-propelled options.

Disc or sickle cutterbars

  • Disc cutterbars. Rotating discs cut quickly and handle heavy crops. They need more power and care with stones.
  • Sickle cutterbars. A reciprocating knife is simple and runs on less power. It can plug in heavy crops if not set well.

For rough ground see renting a sickle bar mower for rough terrain, and for pasture and hay see disc mower rentals for pasture and hay.

Renting a Mower-Conditioner for Hay: illustration of a combine unloading grain into a cart
Illustration: a combine unloading grain into a cart. Original artwork for Farm Equipment Rentals.

Roll or flail conditioners

  • Roll conditioners. Two rolls crush stems. Good for thick stems such as alfalfa.
  • Flail conditioners. Rotating flails scuff the surface. Suited to grasses and some mixed hay.

Rolls come in steel, rubber and combinations. Ask what condition the rolls are in and whether the gap and pressure can be adjusted.

Hitch, size and tractor

Mower-conditioners come in pull-type and three-point models. Check working width, PTO speed, horsepower and hydraulics. A heavy conditioner can overload a small tractor. See utility tractor rentals: sizing guide and row crop tractor rentals.

Setting up

  1. Cutting height. Leave enough stubble for regrowth. For alfalfa this matters especially.
  2. Roll gap and pressure. Crack stems without bruising leaves.
  3. Swath width. Wider swaths dry faster. Match to your rake and baler.
  4. Ground speed. Keep consistent for clean cutting.
  5. Float and skid shoes. Let the cutterbar follow the ground.
  6. Shields and deflectors. Direct crop into a uniform swath.

Check the first pass and adjust. See SARE publications and your state page for regional guidance.

Timing and weather

Cut when you have a dry forecast and good drying conditions. Cutting after dew lifts speeds drying. Avoid cutting just before rain. Hay needs several dry days in many regions. If rain threatens, consider wrapping wetter bales. See renting a bale wrapper for silage and how weather affects rental bookings and fees.

Daily service

  • Grease fittings.
  • Check gearbox and cutterbar oil.
  • Inspect knives, discs or sickle sections.
  • Check belts and shafts.
  • Check tire pressure.
  • Clear wrapped crop from shafts.

Carry spare knives, bolts and tools.

Common mistakes to avoid

  • Cutting too low. Slow regrowth and soil in hay.
  • Over-conditioning leaves.
  • Running dull blades.
  • Ignoring rocks.
  • Skipping daily service.

Inspect before you accept

Check the cutterbar, blades or knives, rolls, belts, gearboxes, driveline, hitch, shields and tires. Test the conditioner. Photograph existing damage. See understanding rental equipment condition reports.

Safety

See the OSHA agricultural operations page.

Transport

Mower-conditioners are wide. Check lights, brakes and road rules. See DOT requirements for rented equipment transport and oversize load permits for rented equipment.

Costs and terms

Ask about daily and weekly rates, delivery, deposit, wear charges and weather delays. See how to budget for farm equipment rentals and understanding rental agreements.

Planning to the baler

A mower-conditioner is one link in a chain. Plan rake, tedder and baler availability so cut hay is not waiting. See tedder rentals for hay drying, hay rake rentals: wheel and rotary and renting a hay baler: round vs square. Cut only as much as you can bale in the dry window. A good rule is to start with a field you can finish rather than every field at once.

Troubleshooting

If the swath is ropey, check speed and shield position. If hay is left uncut in strips, check blades and cutting height. If the machine plugs, slow down and check blade condition. If the conditioner wraps, check roll gap and clean the shafts. If the tractor bogs down, drop speed or reduce width.

Reading the field

Walk the field before the first pass. Mark rocks, stumps, wet spots and holes. On uneven ground, adjust float and skid shoes. Note where the crop is lodged or thin, and adjust speed. Plan a cutting pattern that keeps the tractor on firm ground and minimizes turns.

Cleaning and return

Remove wrapped crop, clean the cutterbar, grease fittings and wash off mud. See returning farm equipment: cleaning and fuel rules.

A sample job

A farm with 50 acres of mixed hay rents a three-point mower-conditioner for two days. The farmer cuts at mid-morning, sets cutting height for regrowth and adjusts roll gap after the first pass. Hay dries in two days, is raked and baled, and the farm returns the machine clean.

Questions to ask the dealer

  1. Disc or sickle cutterbar, and what width?
  2. Roll or flail conditioner?
  3. What tractor do you recommend?
  4. What are the wear parts?
  5. What are the return requirements?

Keeping records

Record dates, fields, settings, weather and results. See record keeping for farm equipment rentals.

Bottom line

A mower-conditioner speeds drying and gets hay off the field. Choose the cutterbar and conditioner for your crop, set cutting height for regrowth and service it daily.

Frequently asked questions

What is a mower-conditioner?

A mower that cuts hay and crushes the stems in one pass to speed drying.

Disc or sickle?

Discs cut faster in heavy crops, sickles are simple and need less power.

Do I need a conditioner?

For many crops, yes. It speeds drying and saves time.

How low should I cut?

Leave enough stubble for regrowth, especially in alfalfa.

Keep reading

Harvesting Equipment Rentals

Disc Mower Rentals for Pasture and Hay

Rent a disc mower for pasture and hay: cutting width, drum or disc design, blade care, stones, speed, tractor needs, cutting height, safety and return checks.

Harvesting Equipment Rentals

Renting a Sickle Bar Mower for Rough Terrain

Rent a sickle bar mower for slopes, ditches and rough ground: knife and guard care, cutting height, tractor needs, speed, slope safety, debris, return checks and costs.

Harvesting Equipment Rentals

Tedder Rentals for Hay Drying

Rent a tedder to fluff and spread cut hay for faster drying: rotor types, timing, speed, leaf loss, tractor needs, safety and fitting tedding with raking and baling.

Harvesting Equipment Rentals

Hay Rake Rentals: Wheel and Rotary

Rent a wheel or rotary hay rake: windrow forming, merging, raking speed, leaf loss, tractor needs, ground conditions, setup, safety and a plan to keep hay moving to the baler.