Farm Equipment Rentals
Harvesting Equipment Rentals

Renting a Header Trailer for Transport

Rent a header trailer to move combine headers safely: sizing, securement, brakes, lights, width and permit rules, loading technique, tow vehicle needs and return checks.

5 min read1,101 wordsUpdated November 2026
Renting a Header Trailer for Transport: illustration of a combine unloading grain into a cart

Combine headers are wide, heavy and awkward. Moving one down a public road without a proper trailer is dangerous for you and everyone else. Renting a header trailer is often cheaper than owning one, especially if you move headers once or twice a season. This guide covers choosing the trailer, loading, securing and legal basics.

Why use a header trailer

A header trailer is built to carry a header low and balanced, with the cutterbar protected. Most designs let the header sit on rails or cradles and strap down firmly. A purpose-built trailer reduces damage to the header and lowers the risk of load shift. It also lets you move a header behind a pickup or tractor instead of leaving it on the combine, which is useful when a combine travels with the header removed.

Choosing the trailer

  • Length. Must carry the header's full width, with room for the reel.
  • Weight rating. Headers and gear can weigh several tons.
  • Axle count and brakes. Electric or hydraulic brakes are required for many loads.
  • Deck type. Some trailers have rails, some have flat decks with cradles.
  • Tires and wheel wells. Check condition and rating.
  • Lights and reflectors. Needed for road travel.
  • Tow vehicle needs. Hitch type, tongue weight and brake controller.

Ask the dealer for the trailer's gross weight rating and recommended tow vehicle.

Renting a Header Trailer for Transport: illustration of a combine unloading grain into a cart
Illustration: a combine unloading grain into a cart. Original artwork for Farm Equipment Rentals.

Width, permits and rules

Wide loads can require permits, flags, lights and escorts. Rules vary by state and road. Check width, length and weight limits before you plan the route. Many farm headers are narrower than legal limits when loaded properly, but large draper headers often are not. See oversize load permits for rented equipment and DOT requirements for rented equipment transport, and the FMCSA for federal rules. Check your state page for state resources.

Loading the header

  1. Park on level ground and chock the trailer.
  2. Detach the header from the combine following the manual.
  3. Move the header onto the trailer slowly, with a spotter.
  4. Center the load and distribute weight so the tongue carries the right share.
  5. Lower the cutterbar and lock any transport features.
  6. Fold or secure the reel and guards.
  7. Strap and chain the header according to the manufacturer and local rules.

Never rely on the combine's hydraulics to hold a raised header while you work beneath it. Use the safety stops.

Securing the load

Use rated chains or straps at multiple points, and check them after the first few miles. Avoid straps over sharp edges without protection. Cover the knife and guards to protect people and equipment. Keep the cutterbar from bouncing. Use reflective tape and flags if the load overhangs. See the equipment transport tie-down checklist.

Tow vehicle and route

A heavy trailer needs a capable tow vehicle with enough hitch rating and brakes. Plan the route to avoid narrow bridges, low wires and tight turns. Drive slower than you would with an empty trailer, leave extra stopping distance and avoid rush hours. Carry a spare tire and a jack. Check forecast for wind, since wide headers catch crosswinds.

Common mistakes to avoid

  • Undersized trailer. Overhang and instability.
  • Skipping permit checks. Fines and delays.
  • Weak tie-downs. The header shifts.
  • Forgetting the reel. It can move or catch wind.
  • Poor lighting. Dangerous at night.

Inspect before you accept

Check the deck, welds, tires, wheel bearings, brakes, lights, safety chains, coupler, jack and ramps. Test lights and brake controller. Photograph existing damage. See understanding rental equipment condition reports.

Safety

  • Use spotters when loading.
  • Keep people away from moving headers.
  • Lock out the combine before detaching. See the farm machinery lockout-tagout procedure template.
  • Wear gloves around the knife.
  • Watch for power lines when raising the feeder house.

See the OSHA agricultural operations page.

Costs and terms

Ask about daily rates, deposit, damage terms, delivery and late fees. If you rent the header too, ask whether the trailer is included. See how to budget for farm equipment rentals and understanding rental agreements.

Cleaning and return

Sweep off dirt and crop residue, remove straps and check tires. Return the trailer with its chains, ramps and keys. See returning farm equipment: cleaning and fuel rules.

A sample trip

A farm rents a 35-foot flexible draper header and a 40-foot header trailer. The farmer checks permit rules, finds the load is slightly over width and arranges flags and a lead vehicle. They chain the header at four points, check tires and drive a short route in daylight. After two miles they stop and retighten the straps.

Questions to ask the dealer

  1. What header sizes does this trailer carry?
  2. What tow vehicle do you recommend?
  3. Does the trailer have brakes and lights?
  4. Are chains and straps included?
  5. What are the return requirements?

Planning the move

Before pickup, measure the header's width, height and weight, and compare them with the trailer's rating and the legal limits on your route. Decide who will drive, who will spot and where you will stop to recheck straps. Carry gloves, a tire gauge, a flashlight, reflective triangles and spare straps. Call the dealer or the owner to confirm the trailer's brake type, since electric and hydraulic systems need different connections and controllers.

After the trip

At the destination, unload on level ground with a spotter and lower the header slowly onto blocks or a stand. Keep the knife covered until the header is mounted. Walk around the trailer and look for loose straps, scuffed tires and anything that shifted. If the trailer will be reused for another header, recheck the securement points, since each header has different tie-down locations. Report any damage right away so it is not charged to you later.

Keeping records

Note the pickup date, trailer condition, tire pressures, tow vehicle and the route you used. Photograph the load before leaving and again on arrival. These notes protect you if a question comes up about damage or a road stop, and they help you plan next season's move.

Bottom line

A header trailer protects the header, the road and you. Choose one that fits, check rules, secure the load and inspect the trailer before you go.

Frequently asked questions

Can I tow a header on the road without a trailer?

Some combines transport headers on the machine, but wide loads still need care. A trailer is safer in many cases.

Do I need a permit?

Possibly. Width and length limits vary by state.

What tie-downs should I use?

Rated chains or straps at multiple points, following the manufacturer and local rules.

What tow vehicle do I need?

One with the right hitch rating, brakes and stability for the loaded trailer.

Keep reading

Harvesting Equipment Rentals

Renting a Forage Wagon for Silage Transport

Rent a forage wagon to haul chopped silage: capacity, unloading type, axles and brakes, tractor needs, field and road safety, matching harvester output and return checks.

Harvesting Equipment Rentals

Renting a Carrot Harvester for Vegetables

Rent a carrot harvester for vegetables: top-pulling vs lifting types, soil moisture, topping, bruising, sorting and cooling, labor, safety and costs for small growers.

Harvesting Equipment Rentals

Soybean Combine Rentals: Flexible Headers

Rent a combine for soybeans: flexible draper or auger heads, low cutting height, reel settings, pod shatter, moisture windows, losses, field prep and residue management.

Harvesting Equipment Rentals

Renting a Bale Wrapper for Silage

Rent a bale wrapper for baleage: in-line vs single bale wrappers, plastic layers, moisture targets, wrapping timing, tractor needs, storage, safety and costs.